HAMDig

The latest projects here have been mostly allstar related.

Node 43193 is connected to a Kenwood TM-V71, as a frequency agile remote base... I will work on having the radio pretuned to channels with nets for the mentally challenged.

Ch macros so far;
https://imgur.com/a/iNPDPsI

43337 is connect to a low band Maxtrac that has been converted to 6 meters, parked on 52.525

And an EIA to N connector
https://imgur.com/a/EZdSaL0

I think the network daemon version doesn't work this is rigctrld. I can connect to it on port 2532, but I never get anything back.
It would be nice to let the remote user know what channel/freq the radio is presently tuned to. I was going to have a web page that would show this using the same stuff I was doing with my receive only IC-706. So the only way to determine that is
from rigctrl
"rigctl -r /dev/ttyUSB0 -m 2035 m" to return the channel number or an "f" at the end for the frequency.
I don't think there is a way to announce this upon connect to just the remote user and not also over the air with allstar?