The latest projects here have been mostly allstar related.
Node 43193 is connected to a Kenwood TM-V71, as a frequency agile remote base... I will work on having the radio pretuned to channels with nets for the mentally challenged.
Ch macros so far;
https://imgur.com/a/iNPDPsI
43337 is connect to a low band Maxtrac that has been converted to 6 meters, parked on 52.525
And an EIA to N connector
https://imgur.com/a/EZdSaL0
Allstar &
Re: Allstar &
I think the network daemon version doesn't work this is rigctrld. I can connect to it on port 2532, but I never get anything back.
It would be nice to let the remote user know what channel/freq the radio is presently tuned to. I was going to have a web page that would show this using the same stuff I was doing with my receive only IC-706. So the only way to determine that is
from rigctrl
"rigctl -r /dev/ttyUSB0 -m 2035 m" to return the channel number or an "f" at the end for the frequency.
I don't think there is a way to announce this upon connect to just the remote user and not also over the air with allstar?
It would be nice to let the remote user know what channel/freq the radio is presently tuned to. I was going to have a web page that would show this using the same stuff I was doing with my receive only IC-706. So the only way to determine that is
from rigctrl
"rigctl -r /dev/ttyUSB0 -m 2035 m" to return the channel number or an "f" at the end for the frequency.
I don't think there is a way to announce this upon connect to just the remote user and not also over the air with allstar?
Who is online
Users browsing this forum: No registered users and 1 guest